Main Page Sitemap

Ademco vista 20p manual

ademco vista 20p manual

See Wire Run Chart for Up to 50 feet # 20 wire size to use.
Connect the Red and windows server 2008 workgroup mode Green LED wires to the appropriate output 17/output 18 trigger connector pins.
Remove the 2000 ohm EOL resistor if connected across the selected zone.Connect open circuit devices in parallel across the loop; for eolr zones, connect the eolr across the loop wires at the last device.Use the connector harness supplied with the module.Vista-15P / vista-15psia, security Systems, installation and Setup Guide, k5305-1V5 10/04 Rev.See Wiring the AC Transformer section for transformer connections.
See Keypad Programming Fields (fields ) in Section.
Make 12V and and data in and data out connections pes 2013 patch srpski komentator from the phone module to the control, using the.

Connect the 4146 keyswitch's normally open momentary switch to a zones (2-8) terminals.Connect each module to the controls keypad terminals and set the device addresses as previously described in the Connecting Keypads and Other Addressable Device section.50100 feet # 18 Use caution when wiring the 100-250 feet # 16 transformer to the control to guard against blowing the transformer fuse 1 2 (the fuse.Summary of Contents for Ademco Vista-20P.The 5800TM can be used in partition 1 only.Connect closed circuit devices in series in the high side of the loop; for eolr zones, connect the.Previous page, next page, advertising, also See for Ademco Vista-20P, related Manuals for Ademco Vista-20P.More Info, page of 56, k5309-1V1 8/01 1, technical Manuals Online!3 4 Total current drawn streets and trips key generator from this output cannot exceed 2 amps (going beyond 2 amps will overload the power supply, or may cause the electronic circuit protecting the sounder output to trip).One diagram shows connections when a Connections 4285/4286 Phone Module is used, the other shows connections when the 4285/4286 is not (AAV, listen-In) used.Use standard 4-conductor twisted cable for long wiring runs.