Rosemount 3051sfc installation manual
Transmitter Housing Set windows converter standalone server Screw better view the optional LCD display:.
B7M Stainless Steel (SST) 150.-lbs.
Refer to appropriate approval certificate.
Signal Wiring Grounding Do not run signal wiring in conduit or open trays with power wiring, or near heavy electrical equipment.With the Rosemount 3051 Pressure Transmitter, you'll gain more control over your plant.Fill impulse lines with water.Step 3: SET switches AND jumpers If alarm and security latest gk and current affairs pdf adjustment option is not installed, the transmitter will operate normally with the default alarm condition alarm high and the security off.Zero Trim A zero trim is a single-point adjustment used for compensating mounting position and line pressure effects.Intrinsic Safety Consideration: The transmitter assembly with remote display has been approved with Belden 3084A DeviceNet cable.It also provides the basic electronics guidelines for the 3051SFA (reference manual document number 3051SFC (reference manual document number and 3051SFP (reference manual document number ).
Torque values for the flange and flange adapter bolts Bolt Material Head Markings Initial Torque Final Torque Carbon Steel (CS) 300.-lbs.
Rosemount 3051 Pressure Transmitter.Rosemount 3051C Coplanar Pressure.Connect the positive lead to the terminal, and the negative lead to the terminal.(See Figure.) Keep the vent path free of any obstruction, including but not limited to paint, dust, and lubrication by mounting the transmitter so that any contaminants.Belden 3084A DeviceNet cable includes a ground shield.Please review the approvals section of the 3051S reference manual for any restrictions associated with a safe installation.Use 24 AWG to 14 AWG wire and do not exceed 5,000 feet (1500 meters).Place taps in the top or side of the line.OHG Argelsrieder Feld 3 82234 Wessling Germany T 49 (8153) 9390, F49 (8153) 939172 Beijing Rosemount Far East Instrument., Limited.Alternate cable may be used as long as the transmitter with remote display and cable is configured according to the installation control drawing or certificate.If the desired location cannot be achieved due to thread limit, rotate the housing counter clockwise to the desired location (up to 360 from thread limit).